broken plastic 'connector' plate - dji zenmuse h3-2d. Where can i get spares?

[jomk63]

After some good fun flying, the ground suddenly came up and hit my hex 

I';m still in two minds whether the flimsy 10mm carbon tubes in the 680pro landing gear were either
a) great - they did their job and broke it';s fall and not a lot of other damage  OR
b) flippin'; useless - both broke into two pieces when they should have done their job and held firm  ?   

However - apart from the landing gear tubes, the only damage was to the attached bracket on the gimbal. This is the original dji bottom bracket - not the (ebay £17) adapter which fits it onto the Tarot 680.

I cant find this as a spare part anywhere.      Does anyone know where i might get one or can anyone 3D print one?  TIA.  J

[FlyingMouse]

Is this what you are looking for!! 

http://www.buildyourowndrone.co.uk/dji-zenmuse-h3-2d-dampening-connector.html

if so I have purchased from them, no trouble!

[jomk63]

   Thanks Flying Mouse. I think this is where i bought my original naza v2 and the gimbal in the first place - but was about the only place i hadnt checked for spares. I hope the screw holes are in the right place - they look slightly different, buy i';m pretty sure they will fit. 

J

[FlyingMouse]

Happy to help, that's what this great forum is all about. Hope your back in the air very soon.