Can you tell me where to plug in for overide?

[Smiler]

My camera gimbal just arrived, 8 days from China but no manual and the board doesn';t look exactly like other Martinez type boards but I';m pretty sure it is. What I would like to know is if anyone can tell me where on the board I connect a servo lead to my receiver so I can override tilt.





Many thanks for any help

Jeff.

[Smiler]

Sorted it.

For anyone else needing the info, the three connectors top right are where you need to look. The one furthest left is GND and the other two are either roll or pitch. Just connect a lead between your Rx and these pins and all is brushless heaven.

Super easy to configure using the setup guide in this forum (thanks for that) took 10 minutes ::)

Regards,
Jeff.