I want to get some new cables and or connectors, UK source preferred

[P3adv-flyer]

Hello.
I wish to replace the controller to antennae leads shown in one of the attached photos, (you may have to 'open' their photo to see the full image, I see only a cropped version in the preview) they do not bend in smooth curves but bend at localised points with small bend radii. I believe the ends are referred to as "RP-SMA male", is that correct?
Can anyone give me links for a trustworthy supplier/s of good cables? UK preferred or somewhere from where I will not incur import duties, the latter seems to rule out USA.

The controller shell (DJI GL300C) was knackered and has been replaced, I would prefer to avoid drilling the shell but the bulkhead fittings are not long enough to pass them through the original antennae mounting holes. Are cables available with somewhat longer bulkhead fittings, if so from where? Again this seems to rule out the "Clean install kits" from the USA that I have seen. It would also seem that they will require a bush or sleeve as the fittings have a diameter that is smaller than the bore of the original antennae holes, are such bushes "off the shelf" items or made specifically for kits?

What is the name of the bulkhead fitting and am I correct in thinking that the connector to the circuit board is a MMCX, presumably, male?

Thanks

PS does anyone know of a UK source for the for clip-on mounting bracket of a Itelite DBS20.2 for DJI Phantom 3 Adv's






,

[atomiclama]

Sorry can't help with a UK supplier, but I've not had any problems with ordering my replacements from ebay. Just takes some time.

[P3adv-flyer]

Thanks, ordered some bits via ebay, fingers crossed.