Naze32 and GPS Problems

[timmsm]

Hi Everyone.

I';ve been flying my 250 for a while now and decided to add GPS to it for something else to "play with".  The problem is I can';t get iNav to see that I';ve got a GPS receiver even through I';ve enabled GPS on UART2 and enabled GPS in the configuration tab, set the protocol to Ublox tried every option for ground assistance as well as every option for baud rate. 

When I connect the Neo 7 to my FTDI board and use U-centre I pick up lots of satellites nice and quickly so I know the GPS receiver is working correctly.

I';ve also made sure that TX goes to RX and RX to TX.  I';ve update firmware to latest version also for the GPS.

I';ve now spent about 3 hours on this and can';t find anything in the forum that I haven';t already tried

Any ideas please?

[ched]

I have no experience on naze32 but does the naze32 and the GPS need baud rates settings to match?