Phantom 1.1.1 Upgrade with advanced camera and gimbal

[lighty]

Can anyone tell me would it be possible to fit and advanced camera from phantom3 with the gimbal to a phantom fc40? Obviously I already have Naza V2 (orange) and I have the v2PMU that i bought in order to fit my zenmuse a while back.
Thanks In advance.
paul

[lighty]

my main issue was voltage requirements?due to phantom 3s battery

[BYOD]

Can anyone tell me would it be possible to fit and advanced camera from phantom3 with the gimbal to a phantom fc40? Obviously I already have Naza V2 (orange) and I have the v2PMU that i bought in order to fit my zenmuse a while back.
Thanks In advance.
paul

The concern Lighty has pointed out is correct, however there are a lot of other things going on inside a Phantom 3 that connect up to the camera system. I would point out that I have not tried this so could not say for sure in either direction, you might be doomed to failure or will be punching the air after a total win. I fear that it will be the first of the two. The Vision+ was about as close as I have seen to the internal connectors on the PCB of the Phantom 3.
I would also question, with the cameras costing (new) more than the FC40 why take the risk? You could buy the Phantom 3 Standard for £450 which will be better than the FC40 on so many levels I would not like to list them all here.
If you think I have missed something on the FC40 upgrade let me know I will take another look at it for you.

Regards

Martin