Motolab Cyclone STM32F3 Flight Controller

[Hands0n]

And yet another to hit the market, taking on the ground previously uniquely occupied by the SPRF3 .

Priced at USD 37 (thats GBP 25.64 at today';s rate) this board is packed with good stuff, including an on-board BEC allowing the FC to be connected direct to the LiPo mains up to 6S.

Full info here --> http://impulserc.com/motolab-cyclone-stm32f3-flight-controller

The design also provides:

- An on-board 600mA switching regulator for direct connection to lipos up to 4S, or up to 6S with power filtering.
- USB interface independent of UART channels.
- Three hardware UARTs. The UART 2 TxD signal is also pinned out to a connector.
- Reverse current protection on lipo and USB inputs for problem-free ESC calibration.
- Dedicated serial LED output with lipo voltage and GND.
- On-board buzzer driver with 5V and lipo voltage option.
- Built-in VBAT monitor with low-pass filter from lipo input.
- Built-in RSSI monitor with low-pass filter.
- Dedicated SAT receiver interface with 3.3v using JST connector for compatibility with Spektrum/LemonRC cables.
- Dedicated PPM and serial receiver interfaces with 5V power using 0.1" headers.
- Compatibility with receivers using Spektrum 1024/2048, SBUS, SumD and SumH receivers with built-in inverter.
- High-quality gold plated 4-layer printed circuit board.
- Connector arrangement for convenient access to serial interfaces, with PWM and other device connections on sturdy through-hole pin headers.

[antrax86]

Anyone tested one out yet?

[Cheredanine]

Unlikely, it is literally just out, even if you ordered by courier I doubt it would have crossed the pond by now

It looks good, spi port to gyro gonna please the raceflight boys if they can sort their filters :)

Going to have the same problem as the lux with blheli flash through until the code is sorted