Telemetry lost swapping baseflight to cleanflight...

[Stevie]

Hi

I';m new to this so dont assume I havent missed something obvious!

All was working perfectly with my new HMB235, Taranis, Naze32 v6, D4R-II. Very pleased.

I bought some programable LEDs
http://www.ebay.co.uk/itm/321943703381?_trksid=p2057872.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT
to help with orientation, but Baseflight didn';t seem to have a way to configure them.

So I swapped to Cleanflight because I found a Painless360 YouTube video about setting up LEDs. The Cleanflight version that I';m using is 1.1.0.

I had to reflash the board and start from scratch. I';ve got everything working again, including the LEDs but the telemetry has stopped working. It used to send me Lipo voltage when I pulled the SH switch. Now it just always says "zero volts". Like it used to do before the board was armed. 

I';ve switched on the ';telemetry'; option in the ';other features'; bit of the configuration screen.

Any ideas what I am missing?

ta!
Steve

[SlipperySquid]

you';ll have to enable telemetry in the "ports" section of cleanflight setup I believe.

You may have to set up "Softserial" also as your hardware ports maybe already used (LEDS use one Uart I believe and your RX and USB) I could be wrong.

Oh and I think you have to invert telemetry via the cleanflight cli...There';s a post on here somewhere.

[Stevie]

you';ll have to enable telemetry in the "ports" section of cleanflight setup I believe.

That';s it! You are a genius. Don';t you just love forums?!