Q Brain 4-in-1 Esc programming pads

[Chippercheese]

Hey guys - would anybody know the correct orientation for the programming pads on these escs? Looking at other silabs escs of a similar size, the convention seems to be chip above pad (like on the left side of this pic)

With the assumption that the pads run in standard order (left to right -> gnd, c2ck, c2d)

Anybody able to confirm?

Thanks!

EDIT: Ok, so I tried it - and flashed BLHeli successfully using the pins as described above. (Currently using Turnigy Plush 25a firmware on each esc - will trial and error to see if that is the wrong firmware).

[homeslice976]

EDIT: Ok, so I tried it - and flashed BLHeli successfully using the pins as described above. (Currently using Turnigy Plush 25a firmware on each esc - will trial and error to see if that is the wrong firmware).

I';ve been considering this as well (thanks for being the first guinea pig I';ve found on the webs for the 25A Q-Brain). Are you still flying with the Plush 25a firmware, or have you found a better setup?

[Chippercheese]

I';ve been considering this as well (thanks for being the first guinea pig I';ve found on the webs for the 25A Q-Brain). Are you still flying with the Plush 25a firmware, or have you found a better setup?

I';m not actually flying with it - flashed it, tested with motors once, then put it in my spares box haha!

[canterburyflyer]

Hi there,
I have just purchased the QBrain25A Quad ESC for a project, always wanted one and now I have an excuse,. Yeah :-) So I wanted to ask you about the firmware you are currently using?
From your post I understand that you have tried BLHEli for the Turnigy Plush 25A. So how did you make out? Is the multi esc just 4 x plush 25';s or some other. In the Quick ESC Reference Guide it mentions a Skywalker Quattro 20 which they have some FW for. I would like to get the best performance naturally.

Any assistance would be very much appreciated.
Thanks,
C