Tarot 2D Gimble

[kljw]

Hi
Just taken delivery of my FY680 and a few other bits and bobs, like the tarot 2D gimble. When starting to assemble the gimble, the mounting brackets included look nothing like that shown in the instructions, not is there any guidance as to how to connect the wires to motors and gyro.
Have attached a photo to show what I have got.


UPDATE
Found a picture on the net, assembled and nearly working.
Do you need to calibrate and if so, how? When I apply power, it buzz';s allot but does try and keep the platform stable.

Also still unsure of the what connectors does what if anyone can help.

Keith

[mutley2]

You';re right, I';ve a Tarot 2D and that mount looks nothing like mine, also the should/were pr-assembled apart from the mount. I still took mine apart and 248';ed all the screws, have a look on you-tube and you will find loads of vids on mounting, set-up and gains.
Great little gimbal that give good results for the money. 

[ControlThis]

They are amazing gimbals. Have had mine for a while and love it.

[kljw]

Hi
All working now and allot of thinking was involved. The last stage will be to connect to the receiver in order to control angle.
I have attached a picture of the pins I need to connect to, but I have no info about what pin does what.
The supplied cable splits into three separate connectors, all with 1nr wire.
Any thoughts on what goes where?

Keith

[mutley2]

Try this, straight forward ;-)
Tarot 2D Brushless Gimbal, How To setup TILT, ROLL, Center. for HERO 3

[kljw]

Mutley2
excellent, exactly what i needed.

thank you

Keith

[mutley2]

No probs, now go shoot some vids 

[kljw]

Just need to finish the build and get a gopro, then skies the limit lol