Welcome to Multi-Rotor UK. Please login or sign up.

Wednesday,November 27, 2024, 04:44:35

Login with username, password and session length

Shoutbox

Bad Raven:
12 May 2024 08:13:51
 I have some F1 Abusemark boards going spare,,,,,,,,,,,,,    ;)    :azn
DarkButterfly:
11 May 2024 22:12:29
And with oldskool parts  :D
DarkButterfly:
11 May 2024 22:11:57
I must be the only one doing tricopters right now  :laugh:
DarkButterfly:
11 May 2024 22:09:30
 :D
Gaza07:
11 May 2024 21:15:16
Domain has been renewed closure has been cancelled  :D
Gaza07:
02 May 2024 08:07:52
Who are most people ??? I think the person you are referring to has put in a lot of effort to keep things moving  :rolleyes:
hoverfly:
01 May 2024 10:16:12
Most people I have spoken to are pizzed off with the yellow peril  flooding the forum,go figure. :whistling:
Gaza07:
23 Apr 2024 08:09:45
The Domain expires for the forum in 60 days, I'm not going to renew it this time unless I see any activity  :beer2:
Gaza07:
20 Apr 2024 18:02:50
Is there anyone who would like to see this forum stay open ? :shrug:
hoverfly:
17 Apr 2024 17:15:13
 :rolleyes:
Members
Stats
  • Total Posts: 201,498
  • Total Topics: 20,274
  • Online today: 22
  • Online ever: 530
  • (Tuesday,June 26, 2012, 08:34:46 )
Users Online
Users: 0
Guests: 20
Total: 20

Theme Changer





3d - Printworx

Inav problems

Started by hoverfly, Wednesday,March 14, 2018, 13:18:38

Previous topic - Next topic

hoverfly

@ Wyntrblue.
board is
Matek F405-CTR AIO Flight Controller,  with  inav_1.9.0_MATEKF405-RC1.hex this one was advised by Hobbyrc after i was unable to load the ones on the Inav  config.

The second one that loads but is not suitable is..inav_1.8.0_MATEKF405.hex This one is recommend by Matek.
I had another look this morning but the deeper i look i suspect a bug. :cry

Reptile folder , alien 500 , F/ Shark Attitudes,
 .Tarot 650, Air-rio Kinetic.. DX9  Various wings and planks.. Taranis x9D+..Mavic..Armattan.. Chameleion...
Massive over draught.....

Wyntrblue


hoverfly

#2
That was the one that Hobbyrc recommended. it had the least problems.Everything looking good but not arming.
Motor test was ok , only indication of problem apart from not arming was when i set the failsafe to a switch it worked in the mode tab but is i navigated away it turned off again,  in the instructions it states that if there is a conflict with a setting it will cancel it., for example using same port for two functions.. the more i look at it i suspect a bug. all the previous boards have worked well. :shrug:

Edit when i loaded the second firmware when i tried to calibrate it only did level the six position  calibration window didn't  appear.
Reptile folder , alien 500 , F/ Shark Attitudes,
 .Tarot 650, Air-rio Kinetic.. DX9  Various wings and planks.. Taranis x9D+..Mavic..Armattan.. Chameleion...
Massive over draught.....