Weird NAZA-M V2 Mode Calibration Issue

[nate80]

I';m setting up a Taranis X9D+ and a NAZA-M V2.  I';ve figured most of it out and have the sticks and switches configured in the Taranis menu, but I';m having a really weird issue in the Naza Assistant software (newest version 2.20).  The Naza-M V2 firmware is also the newest version, as is the Taranis and even the X8R RX.  All updated successfully a couple of days ago.

I';m trying to configure the Control Mode Switch (channel 7 / SE 3 position switch on the taranis) in the BASIC / RC section of Naza Assistant.  I selected ';Manual'; from the drop down menu on the far right and adjusted the Servos menu in the taranis so that the little arrow aligns correctly beneath GPS, Atti and Manual.  But when the SE switch is in its third (down) position and the arrow in the Naza Assistant is below (and perfectly in the middle of) Manual'; the ';Failsafe'; mode is still the one highlighted in blue!?

I don';t know what to do next as the arrow is in the correct position on the line.  I';m completely stumped.     please!

[GdLookinMingeR]

This may help
http://www.youtube.com/watch?v=-gA5o_g4oW4

Jay

[nate80]

Cheers Jay.    That was a big help.

I had come across that video already but I';d visited so many webpages and saved so many bookmarks I couldn';t see the wood for the trees.  Due to trying earlier fixes (that failed) I had to reset the Taranis to default and start again.  I followed the guide and it works!   ::)