No radio response after new version was flashed

[sirrtoby666]

I wanted the new beta Megapirateng 2.9 and i downloaded it and installed it as i should, but now when i try to move the radio after the installation "in Missonplanner" there are no response in radio calibration.

The card seems to be work properly. I checked the compass, barometer and all of the other stuff and they seam to work fine.

What can be the problem. 

[firey1]

with megaP 2.9.1 r300
ppm has been enabled in the aph config
this needs to be disabled

[firey1]

what i do before flashing an update is check changes in the source section of mega P page as this shows what changes has been made

you will also see that the transmitter has been changed from mwi to standard so have to watch out for that too as its set for mode 1 transmitter

[Gaza07]

Also check the Tx Define its prob on standard and you prob need mwi 

Code Select Expand

#define TX_CHANNEL_SET TX_mwi

[sirrtoby666]

I have changed the radio settings and all seams ok but i will try with "disabled ppm"

Thank u boys for now...have a nice evening