failsafe

[tonygoole]

hi all

sorry I have been off the scene for a while and my memory is terrible... im trying to set up the failsafe for when I go out of range or the transmitter dies. just been watching a video and when I turn the Tx off I need the pwm to drop below 900 or 990?

im having the opposite effect throttle at idle is giving me 1041 when I turn Tx off it shoots up to 1436.... the video says use you end point adjust to get to the value you wish but I cant get no where near it.... im using turnigy 9xr Tx

can anyone point me in the right direction please

[tonygoole]

I think I got it, the video I watched said set throttle to half and then push the button on receiver.... this time I set the RTL safety switch then pushed the button on the receiver. now it RTL when Tx is off.

Will this really RTL when I flick the RTL switch as long as I have a valid GPS lock when I take off, just too scared to try it in case it flys off somewhere never to be found again... I know it wont can anyone re-assure me 

[nub]

no idea about the 9xr or the Rx that you may be using with it, but it sounds like it may have it';s own failsafe setup and that';s probably why your throttle is jumping up when you cut the signal.

yup sounds like you';ve may have sussed it i think, but don';t quote me though