naze32 with sat and gps

[Petetheboat]

Hi,
Hi
I am new to the naze32 however have got it fly really well.
But I am Trying to get the gps to work. But it won';t see it.
It';s a ublox 6.can get to work in the ublox program great.
With a baud setting of 19200.but the naze won';t see it at all
I am using a spektrum DSM X Sat.
Please can any one help
The settings in clean flight are now:
Ports tab
softserial 1 gps 19200 and the box is ticked.
config tab
GPS enabled, ublox protocol, european ground assitance type
Mag dec -2.1

Other features
softserial ticked
telemetry ticked
display oled screen display ticked

Also tx/rx from the gps connected to connections 5/6 on the non motor connections side

The gps is still not working.

even fitted a spare board I had just in case its not working.

I have not entered anything into the CLI for the gps. As I assumed that ticking the boxes, would sort it.
Getting really frustated.
Any further pointers would be great 
Thanks
Peter

[Revs]

I';ve no experience in fitting GPS to the Naze32, but this guys vids are generally very good.. https://www.youtube.com/watch?v=ImFCE-qdOi8

Also, Danny has done a guide, here http://www.multi-rotor.co.uk/index.php?topic=9950.0

Welcome to the forum, Peter

[Tim2100]

Pin 5 is for leds,  you want the pins 4 and 6 iirc

[Petetheboat]

Thanks for the reply.
Pin 4 is used by the sat.
Pete

[Petetheboat]

Hi all,
Thanks for the above help.
I have spent hours trying to get the gps with the spektrum dsmx sat to work and no success.
I got the GPS working great with a Spektrum AR9020 9 ch rx. The Gps was connected to pins 3 and 4. However if I do a setup for a hex. How do I connect the extra channels from the rx to the naze so I can set the gps home and gps hold.
Thanks in advance
Pete