What software to use to activate tilt via transmitter for goodluckbuy gimbal

[Johnc]

What programme do you use  to activate tilt control via transmitter on a low cost goodluckbuy 2 axis gimbal, or is it just a case of wiring it up as it is?
Also how to wire it up, do you go straight to the receiver with all three wires or just use the signal wire?

Has any one got a copy of wiring diag that I can use.
Any help or advice would be great,

Thank you,
John

[JerryCampbell]

I assigned a "Pot" to a channel in my Transmitter, Then I wired the same receiver channel direct to the Gimbal using the signal and ground only. Works great.

[Johnc]

Should have said, which pins of the 12 do I use?

photo attached,
Cheers,
John

[Airwave45]

it might ? be this board on the camera gimbal ?

Which shows which pins to put the channel cables onto

[Jumpy07]

Would need better picture of Gimbal controller board..  Goodluckbuy used a lot of different boards.. some of them run Alexmos software.. if so then you will need the correct GUi for the firmware installed.. 

Try some of the GUI';s from here http://www.basecamelectronics.com/downloads/8bit/

[Johnc]

Thank you for the quick reply. Just a quick question, do I use all three wires from the receiver or just the two as suggested in the earlier post?
Cheers,
John

[Johnc]

Thank you for the help, just needed to find the right connections for signal & ground wires and now tilt works via slider on the transmitter.
Thank you again,
John