Ezosd help

[Nobby.fpv]

Hi all I';m just about to get the immersion ezosd and I would like some help setting it up on my tbs discovery Iv got the fat shark video tx and camera on it. But I';m looking to get a new camera later that will be 12v just need help with how and where to solder the connectors thanks for any help you can give me

[flybywire]

I have an ezosd on my dji 450, it';s pretty much plug & play, that';s the good thing about immersion gear. 
Go onto the immersion site & download the schematic, then you';ll have made sense of it by the time it arrives!

[Jumpy07]

If you are not using the core.. then these might help





If you are using the core...

[Nobby.fpv]

Thanks for pic but can I wire it like that as I have a 5v can and a 12v vtx so how would I go about seting that up thanks for any help you can give me

[Jumpy07]

Easiest way is with one of these http://www.firstpersonview.co.uk/psu-regulator-boards/5v-to-12v-step-up

[Nobby.fpv]

Thanks for all the help with the setup of my ezosd it';s all setup and working just need to know how to firmware update it to see if it';s all up todate. Can';t wait to get out and fly this thing now as Iv got a gimbal and video switch so I can switch betwean fpv cam and gopro I';m like a kid at the moment. Again thanks for the help this is my new forum of chose

[flybywire]

Don';t forget, fat shark/immersion vtx are designed for use with 5v cameras, and have a clean 5v supply for that very purpose