Naze rev5 binding RX problem

[Bajadre]

having a few problems with my fc at the mo so bare with me as I don't generally mess about with them much lol  :embarrassed

last couple of flights been getting unbinding between batteries etc,went out sunday for a flight first lipo was fine came in and swopped over tried taking off and one of rear motors wasn't keeping up with the rest and spinning the quad out.

took it home recalled the motors on baseflight (which the fc was setup when I bought it) the decided to try updating to cleanflgiht software where the problems start lol after a day of messing about managed to get the fc boot pins to reflash  and got cleanflight on there and it connects up fine  now when I try to use the CLI command to bind my rx to tx am having problems.been using this guide as it worked fine this way before etc

https://flexrc.com/2016/04/22/how-to-configure-cleanflight-and-bind-dsmx-satellite-receiver/

8. Then connect flight controller to computer and observe that your DSMX satellite receiver is rapidly flashing.

when I get to this stage is where am stuck as when I reconnect the usb the rx light doesn't flash 

some screens of my tabs for the rx etc






the rx says dsmx on it and my dx6 framerate is 22ms mode DSMX

[Bajadre]

turnt out to be a faulty receiver in the end swopped it over for another and binded straight away