Naza v2 beeping zero throttle

[Gav]

Last days I';ve been swapping out a 2.4ghz frsky receiver to a uhf receiver, on a quad.

Now,  strangely the naza v2 will beep when i have 0 to 5% on the throttle stick??? Can';t arm the thing any more.
Naza assistant shows all channels working.
Calibrated the channels
Advanced calibrated the IMU
I';ve even reverted back to the old receiver just to try again. So no reversed channels or anything like that.
Weird!!!!!
Put it in manual flight mode so it didn';t need gps sig
Still beeping if i got to zero throttle on my tranny.
Motor test and all motors spin....it';s not the esc beeping its the NAza unless I';m going mad.
My guess nobody has had this problem but I';d be interested if you have and have an idea to what it could be.
Cheers
Gav

ps just re did a naza dance too.

[Gav]

Well I can arm the naza now no probs.  But weird its about less than 1/3rd throttle and Naza beeps at me - I can';t see where else the beep can come from lol
shut off motors and still beeps - until I arm and throttle up past 1/3 throttle stick -  hmmm never used to do that.

[ched]

Have you tried connecting it to the assistant to see if it gives you an error message in bottom right?

[ched]

Just had a bit of a search as had a few mins and I have a Naza so thought I should know codes.

Throttle stick not at bottom BBBBBBBB
Input signal is abnormal B....B....B....B...
Input Voltage abnormal  BB...BB...BB...BB..

The Input signal abnormal is talking about all input signals, not just rx. So try unplugging gps puck and see if you still get beeps. I have read that the Naza gyros might be ';stuck'; so tap the FC!!! Seems a bit weird as I thought the gyros were sold state?

Anyway hope that gives you a clue?
Let us know what the issue was when you find it.

[Gav]

Just had a bit of a search as had a few mins and I have a Naza so thought I should know codes.

Throttle stick not at bottom BBBBBBBB
Input signal is abnormal B....B....B....B...
Input Voltage abnormal  BB...BB...BB...BB..

The Input signal abnormal is talking about all input signals, not just rx. So try unplugging gps puck and see if you still get beeps. I have read that the Naza gyros might be ';stuck'; so tap the FC!!! Seems a bit weird as I thought the gyros were sold state?

Anyway hope that gives you a clue?
Let us know what the issue was when you find it.

Sounds good. The description would marry up to what i have been doing.  I.e. setting up my uhf rx in ppm mode and playing around with the timing / no of channels.

I will try and revert to the old rx and then check n stabilise everything to get rid of beeps then try uhf setup once more.

I will keep you posted. Cheers m8