nighthawk pro 200 pnp (Betaflight)

[Steve-flys]

Hi i would like to know if i could conect a futaba R2006gs
to the above pictures and links would be great

many thanks

Steve

[Bad Raven]

It is a six channel Tx/Rx like any other, so yes.

Four Channels for flight, one for lost model buzzer, one for flight modes, so don';t expect more. Arming/Disarming by Tx stick.

[Cheredanine]

It is pwm only right? No ppm or serial?

The nh200 has an sprf3 acro flight controller I believe, fortunately this is antiquated, being about 2 years old and can still take pwm, although it is a lot of messing around, so should be possible

[Steve-flys]

with a bit of reserch it has one three pin plug that goes to cppm
not sure how to do it yet
this quad is a plug and play

[Cheredanine]

Yeah I meant the reciever, does that do ppm?

[Bad Raven]

Didn';t know the 200 was sold pnp, they were usually combo kit, the 280 was pnp.

That Rx may well have no serial type output, no serial found in quick look, but AFAICT the 200 comes with Skyline 32 (Nase) flight controller as most Emax, so should have inputs for each channel.

SO a servo lead from each Rx channel to the FC inputs, sometimes done with a loom that only has one three wire signal, pos and neg, but single signal wires only for each other channel.

Is the FC pre fitted with socket, pins or solder pads, again most EMax FC come with a small multi pin socket and a loom in the kit as above.

[Cheredanine]

Didn';t know the 200 was sold pnp, they were usually combo kit, the 280 was pnp.

That Rx may well have no serial type output, no serial found in quick look, but AFAICT the 200 comes with Skyline 32 (Nase) flight controller as most Emax, so should have inputs for each channel.

SO a servo lead from each Rx channel to the FC inputs, sometimes done with a loom that only has one three wire signal, pos and neg, but single signal wires only for each other channel.

Is the FC pre fitted with socket, pins or solder pads, again most EMax FC come with a small multi pin socket and a loom in the kit as above.

The spec I picked up had an sprf3 clone in it, with fc has pwm inputs, but agree sounds like he has given instructions for ppm but Rx only does pwm

[Steve-flys]

Thanks for all replies
iv found that it runs on beta flight on cppm so iv got a tranis ordered and a mini receiver hopefully it will be all done by end of today

[Bad Raven]

Once you get your head round the Taranis you def won';t regret buying it. Assume you have the full range mini Rx, XSR?