Tarot ZYX-M PMU Power Connection

[LuMan]

So, I';ve got my 550 build all soldered up and just need to add the FC and Rx. I';m using the Tarot ZYX-M, as it seems to have all the stuff I need going forward. It';s also got a rather nifty PMU, but I';m in two minds whether to solder the power connections onto the hex';s PDB directly, or fit a couple of plugs and run it from a break-out connector on the battery connection.

I';m not intending on moving the FC to another craft, so I don';t mind a permanently soldered solution (and it';s a 5 minute job to un-solder the connections), but I was just wondering if there';s a perceived ';proper way'; of doing it.

Thanks 

[hoverfly]

I would solder it. Although plugs would add little weight  if it aint fitted it can';t go wrong.

[LuMan]

That';s good enough for me, hv 

Like I said, de-soldering would only take a few minutes, and it';s not like I';m going to need to disconnect the PMU on a regular basis.

I may well have it all ready to set up with Flight Assistant later on 

[hoverfly]

That';s good enough for me, hv 

Like I said, de-soldering would only take a few minutes, and it';s not like I';m going to need to disconnect the PMU on a regular basis.

I may well have it all ready to set up with Flight Assistant later on 

They are a  nice little  F/C, I have one on a Tarot iron man 650.  and it handles it well, i moded the motor mounts to have a little pitch inwards as it helps to prevent  instability from propwash when desending rapidly..