Aeroxcraft X50 arms fitted - Looks fantastic!

[PropsToYou]

If you frequent this sub-forum you';ll probably know that I';ve been debating investing in the AeroXcraft machined arms for my Flamewheel F550 to replace the stock plastic ones for quite some time.

In the end I invested in a set, and whilst I was at it, in the light of the jello issues I';d been getting, also purchased the landing gear isolator set which will hopefully help a little there.

There were a few worries I';d had before buying, one big one being that the size of my E310 ESC';s are far too big to be fitted in the recommended slot of the arms.
I';m happy to say however thanks to a post I found in an obscure German forum, mixed with a couple of additions of my own I have fitted them, and it looks amazing!

I haven';t yet hit the sky with the new build but will feed back once I have.

Here';s a couple of before/after pics as well as some to show how I fitted the ESCs.





For the ESCs I bought some semi-rigid foam, cut it perfectly to fit into the arm, doubled it up and wedged it in underneath to keep it snug and prevent vibrations.

[Rustydiver]

Ooo very posh. Looks professional in black.

I chose bright colours for Ming but they do look so much more better.

[PropsToYou]

Ooo very posh. Looks professional in black.

I chose bright colours for Ming but they do look so much more better.

I fitted the isolator landing gear fitting with silicon spacers and it';s worked like magic! Absolutely irradiated any sign of Jello regardless of how I throw it around!

[DIY_Quads]

Hi - nice build!

Can you tell me the measurement (in mm) between the centres of the 2 holes where your gimbal mount attaches to the 2 landing gear rails? (I am hoping its 60mm)

Also are the landing gear rails which your grommeted mount slides onto 10mm diameter ?

My reason for asking is because the Tarot frames typically have a centre-point distance of about 60mm between the two 10mm diameter rails and I wonder if your mount might fit a Tarot frame.

Thx.

[richardg6paj]

Hi - nice build!

Can you tell me the measurement (in mm) between the centres of the 2 holes where your gimbal mount attaches to the 2 landing gear rails? (I am hoping its 60mm)

Also are the landing gear rails which your grommeted mount slides onto 10mm diameter ?

My reason for asking is because the Tarot frames typically have a centre-point distance of about 60mm between the two 10mm diameter rails and I wonder if your mount might fit a Tarot frame.

Thx.

The rail centres are 68mm and the rails are 12mm diameter.

Richard