how to connect camera shutter (output 46) with camera

[thijs_straathof]

Hi,

I';m trying to make my Crius AIOP v2 board to control my camera shutter,

If I connect a modified USB cable to my camera and put 5v on it it will take a picture.
How can I make my Crius aiop v2 board make the camera trigger. I did see some movies on youtube where a servo presses the trigger. I like to have a 5v output.
Can I do this with output 46.

thanks

thijs

[thijs_straathof]

I did find where to switch from servo to relais, and it works.

[attach=1]

but now i can set it to relais. and i press write to get it on crius. but it would not remember the setting. how can that be?

[thijs_straathof]

I also found out why my setting of relay changed back to servo time after time,

If you go to the gimbal settings to set the duration of the trigger the setting will be reset to servo. so first set the trigger duration time, and then change servo to relay and write parameters.

case closed.

[pashkot]

Hi, I';m trying to connect a camera to my crius aiop v2 board, but I don';t understand what output does pin 46 provide and how I should connect a camera to it. Can you show me your setup? And what cam are you using? Thanks. :)

[fisheye]

hi
signal pin of output 46 -> +5V
"-" pin of output 46 -> GND
"+" pin - not used
settings in MP - as shown before