My simple fpv camera gimbal

[richardg6paj]

Will take the small cased camera, stick camera onto side of servo with either sticky pad or Velcro. And will take a 32mm board cam with suitable plate.
Again stuck on the side of the servo.

Richard

[Trev2971]

are you going to use it to adjust the cam up in FF? , been thinking about doing something like that and adding it to one of the outputs of the naze

good luck 

[richardg6paj]

are you going to use it to adjust the cam up in FF? , been thinking about doing something like that and adding it to one of the outputs of the naze

good luck 

Yes Trev, I';ve had it hooked up to the Naze. I can tilt it with the radio and the naze will keep it there. I';ve not flown with it, as I';m still building my mini quad.

Thanks
Richard

[nub]

looks good, i have a BAH nemesis swivel mount but i';ve yet to mod a frame to take it, i';d like to be able to swap between 2 angles it would be very handy, maybe someday i';ll get around to it

[xxpitt]

if you could fing a way to get it to tilt the hd cam as well, that would be very nice

[richardg6paj]

looks good, i have a BAH nemesis swivel mount but i';ve yet to mod a frame to take it, i';d like to be able to swap between 2 angles it would be very handy, maybe someday i';ll get around to it

Yes, I';ve seen that, is it 3d printed, I designed a camera mount based on it, to incorporate the VTX. (see pictures). The photograph was without pitch.
But I found it was taking up too much room on a 250 quad, so went for the much smaller servo and bracket.

[richardg6paj]

if you could fing a way to get it to tilt the hd cam as well, that would be very nice

If the servo is mounted at 90 degs to what it is in the picture, a Mobius can be strapped to side and a small fpv cam stuck to the edge of the servo.