Plea for help!

[Sanguinius_Z]

Hi folks - not sure if this is the right category to post this in, if not I';d be gratified if an admin could relocate this post to an appropriate category.

I';ve got a DJI F550, Naza V2 Rx, and Futaba T8J Tx. I can';t get the Rx and Tx to bind. No issues with getting the individual motor spool check, etc. via the Naza software, however I can';t seem to get the two bits of kit to play nicely at all. Been following various Youtube videos on calibrating the Tx etc ("alishanmao" channel) but it';s when I get to the use of the Naza software that my progress begins to fall apart.

I';m at the ';suddenly making it fly in to a wall'; now, and so am reaching out to anyone in this community who is located in Scotland - Borders, Lothian, Central Scotland - or even Northern England who may be willing to spare the time to help me out with getting my bird off the deck.

Would be willing to compensate for time spent and services rendered in getting my F550 airborne!

Any offers of assistance or advice would be greatly appreciated.

[Chami82923]

Hi there,

I read your post, and then again, and it struck me that you seem to be confused between your naza flight controller and you Rx module, the naza flight controller will not bind with your tx, it just interprets the received signals from your Tx via your Rx.

Check out the dji wiki pages, it explains most of it:-
http://wiki.dji.com/en/index.php/Naza-M-V2

Good luck,

Callum

[xxpitt]

have you ever flown anything with that receiver and tx? could just be a case the tx and rx are not bound together, you need to bind them, they wont just work together out of the box, like above the naza is the flight controller or FC the receiver or RX is the thingy majig with the antenna